Ecumaster Controller Haldex DragRacing EM-EC-017

The Haldex Drag Racing Controller is a necessary device for every competitor competing in the competition in a quarter of a mile, with a car equipped with a 4Motion drive with the Haldex system, as evidenced by the fact that the leading competitors in ¼ mile racing use this device. It allows the drive to be fully closed during take-off, and it can be automatically disconnected after exceeding the preset speed of the car. The great advantage of the device is the fact that it does not require any additional sensors, which allows the use of the 4Motion drive in cars without ABS. The device is also successfully used in everyday traffic, where the possibility of smooth adjustment of the rear drive coupling with a potentiometer is used. Features of the device: full control of the rear drive short-circuit (50% -50%), adjustment of the drive short-circuit with a potentiometer, the ability to automatically "disconnect" the drive after the vehicle exceeds the set speed, protection against overheating of the oil, "unfastening" the drive with the handbrake on, full configuration of the device + logging its status using a PC, 24-month warranty for the device. Notes: For the correct operation of the controller, it is necessary to modify the Haldex module. It is performed by Ecumaster. Hardware requirements: The following minimum configuration is required for proper cooperation with the device. As modern notebooks do not usually have built-in serial (COM) ports, the device works with popular USB COM adapters. Windows 2000, XP, Vista, Windows 7 Screen resolution at least 800x600 16bit, Processor with a clock of at least 500MHz, Serial port (RS232) or USB converter is RS232. The kit includes: HALDEX DRAG RACING CONTROLLER, RS232 (DB9) HDRC cable, Set of plugs for connecting the device with the Haldex module, Modified Halex module (provided by the customer), Haldex Drag Racing Controller is a necessary device for every competitor starting in the competition for a quarter of a mile with a car equipped with a 4Motion drive with the Haldex system, as evidenced by the fact that the leading competitors in the ¼ mile race use this device. It allows the drive to be completely closed during take-off, and to automatically disconnect it after exceeding the preset speed of the car. The great advantage of the device is the fact that it does not require any additional sensors, which allows the use of the 4Motion drive in cars without ABS. The device is also successfully used in everyday traffic, where the possibility of smooth adjustment of the rear drive coupling with a potentiometer is used. Features of the device: full control of the rear drive short-circuit (50% -50%), adjustment of the drive short-circuit with a potentiometer, the ability to automatically "disconnect" the drive after the vehicle exceeds the set speed, protection against overheating of the oil, "unfastening" the drive with the handbrake on, full configuration of the device + logging its status using a PC, 24-month warranty for the device. Notes: For the correct operation of the controller, it is necessary to modify the Haldex module. It is performed by Ecumaster. Hardware requirements: The following minimum configuration is required for proper cooperation with the device. As modern notebooks do not usually have built-in serial (COM) ports, the device works with popular USB COM adapters. Windows 2000, XP, Vista, Windows 7 Screen resolution of at least 800x600 16bit, Processor with a clock of at least 500MHz, Serial port (RS232) or USB converter is RS232. Set includes: HALDEX DRAG RACING CONTROLLER, RS232 (DB9) HDRC cable, Set of plugs for connecting the device with the Haldex module, Modified Halex module (provided by the customer),