STD main bearings Honda, Acura B18C1, B18C2, B18C5, B18C7 1797cc VTEC Race Series ACL ACL-5M1959H-STD

Main bearings Honda / Acura Std B18C1 / B18C2 / B18C5 / B18C7 1797cc Inline 4 VTEC ACL Race bearings are designed to work in the most extreme conditions and the most demanding engines. the technological process allows the bushing to adapt to the deformation occurring at high rpm and helps in the formation of hydrodynamic oil films. This technology, combined with the advanced geometry of the bushings, makes them an ideal solution for highly stressed engines. -0.025 mm (looser than nominal) STD +0.000 mm (nominal) +0.025 mm (tighter than nominal) +0.25 mm (first shaft grinding) +0.50 mm (second shaft grinding) ACL Race bearings are designed to work in the most extreme conditions and the most strained engines. Thanks to many years of experience in the production of bearing panes, each set is ideally suited to the engine. The advanced technological process allows the bearing to adjust to the deformations arising at high revs and helps in the production of hydrodynamic oil films. This technology, in combination with advanced cup geometry, makes them ideal for heavily strained engines.Most panes are also available in several other dimensions: STDX -0.025 mm (looser than nominal) STD +0.000 mm (nominal) + 0.025 mm (tighter than nominal) + 0.25 mm (first shaft cut) + 0.50 mm (second shaft cut) Main Bushes Honda / Acura Std B18C1 / B18C2 / B18C5 / B18C7 1797cc Inline 4 VTEC ACL Race shells are designed to operate in the most extreme conditions and the toughest conditions Thanks to many years of experience in the production of bushings, each set is perfectly matched to the engine. The advanced technological process allows the bushing to adjust to the deformations occurring at high revolutions and helps in the production of hydrodynamic oil films. This technology, combined with the advanced geometry of the bushings, makes them ideal solution for heavy duty engines Most bushings are also available in several other dimensions: STDX -0 .025 mm (looser than nominal) STD +0.000 mm (nominal) +0.025 mm (tighter than nominal) +0.25 mm (first shaft grinding) +0.50 mm (second shaft grinding)