Adapter Oxygen sensor emulator TurboWorks 8st M18x1.5 MG-IN-005

Lambda probe adapter by TurboWorks 8st M18x1.5. In cars with EURO 3 emission standard, there is a second lambda probe upstream of the catalytic converter. It plays a diagnostic role. If, on the basis of its data, the engine controller detects any irregularities - it will display a CHECK ENGINE error on the dashboard and the engine may go into emergency operation mode. This is often manifested by a large drop in power. The above problems appear in the case of removing the catalyst, its low efficiency or replacing it with an ejector. In such situations it becomes necessary to install a LAMBDA PROBE EMULATOR. The emulator can also help in the event of problems with the LPG system, which, due to the detection of too rich mixture, causes the display of the indicator "CHECK ENGINE" on the dashboard. Specification: Angle: 8 degrees Thread: M18x1.5 Coating: Chrome Simple installation Lambda probe adapter from TurboWorks 8deg M18x1,5. In cars with the EURO 3 emission standard, a second oxygen sensor is located behind the catalytic converter. It has a diagnostic role. If the engine control detects any abnormalities from its data, it will display a CHECK ENGINE error on the dashboard and the engine may go into emergency mode. This often manifests as a large power drop. The above problems appear in the case of removing the catalyst, its low efficiency or replacing it with a jet pump. In such situations, it becomes necessary to mount the LAMBDA PROBE EMULATOR. The emulator can also help in the event of problems with the LPG installation, which due to the detection of too rich mixture results in the "CHECK ENGINE" indicator on the dashboard.Specification: & nbsp