EasyEcu 3+ OM-16529

The EasyEcu 3+ controller is designed to control engines with a maximum number of 8 cylinders. As the software develops, support for various triggers and ignition systems will be added. In the initial phase, triggers in the form of gears, e.g. 60-2, 36-1, and wasted spark ignition systems and on the ignition distributor will be supported. In addition, EasyEcu 3+ has a built-in Bosch LSU4.9 broadband lambda probe controller and a 3-bar MAP sensor. Hardware capabilities (inputs / outputs) of the EasyEcu 3+ controller are as follows: 2 high-resistance injector outputs (in one or two banks) 4 ignition outputs ( passive coils) Note 1 6 logic level 5V ignition outputs (active coils) 1 idle valve (electromagnetic type) 1 idle valve (stepper motor) Note 2 1 fuel pump relay 1 additional output in the open collector with capacity of 3A 1 tachometer output 12V 1 shaft position input (VR or HALL) 1 shaft position input or shaft reference (VR or HALL) 1 shaft position input dedicated for ignition systems with distributor (HALL) 1 vehicle speed sensor input 1 engine temperature sensor input 1 sensor input intake air temperature 1 input of throttle position sensor 1 input of narrowband lambda probe 1 input of temperature measurement y flue gas 2 function inputs (e.g. start procedure switch) 2 analog inputs 0-5V 1 input for additional temperature measurement 2 inputs for knock sensors Note 1 and 2 It is possible to extend the ignition outputs to passive coils by additional 4 channels. Additional ignition outputs are placed on the control outputs of the slow speed valve in the form of a stepper motor. In this option, only the control of the idle solenoid valve is available. In return, we get 8 ignition channels supporting passive coils. & Nbsp